回復 9# Jackiewakusome
You should use a "Din to RCA" line and then the end of "Din" to 202's "AV" instead of "AUX2" and the other end "RCA" to your AV amp's
pre-out.
要用AVBYPASS好似問返威記好D喎,我之前個部set過一次之後就唔記得(幾複雜下架){:6_142:}
正嘢{:6_212:}
恭喜晒呀！呢部正嘢嚟
Ching hi-cap 去202，flatcap 去cd5xs會更好
大聲啲唔代表好有力....{:1_352:}
煲下先啦~
本帖最後由 Big_McIn 於 2011-5-6 02:50 編輯
想問我用 AV AMP 看 MOVIE 時, 將 1 對 RCA 入 202 AUX2, 點先可以自動 BYPASS 看 MOVIE 呢?
Jackiewakusome 發表於 2011-5-5 23:54 http://www.post76.com/discuss/images/common/back.gif
28 Preamplifier and Integrated Amplifier Operation
Many operational and control features of Naim preamplifiers and integrated amplifiers are common to all and are based on a similar user interface. This section of the manual describes those features and the user interface, drawing attention to differences between products where they occur. Table 28.10 sets out some variations in user interface between products.
Front panel controls are duplicated on the remote control handset which may also provide some extra functions. See Sections 29 and 30 for more information.
For the purposes of brevity the term preamplifier in the following paragraphs can be taken also to mean integrated amplifier.
28.2 AV Integration (Unity Gain)
Unity Gain enables an audio-visual processor to be integrated such that its volume control takes over command of signals connected to selected preamplifier inputs. On the NAC 552 Unity Gain may be selected on DIN input sockets 4 and 5. On all other preamplifiers it may be selected on only the av input.
1. To select Unity Gain, first switch the preamplifier into program mode by pressing and holding the handset prog key (with the handset in preamplifier mode).
2. The front panel source mute button (NAC 202 mute button, NAC 152 XS and Nait 5i av button) will illuminate if Unity Gain is selected.
3. If it is not enabled it can be switched on by pressing the same button twice.
See table 28.10.
Unity Gain only becomes operational on exit from program mode by pressing and holding the handset prog key.
Note: The preamplifier will leave program mode automatically if no control commands are received for five minutes.
倘若未能了解英文，嘗試看看以下本人中文翻譯。
1. 搖控選用"Preamplifier" mode，再按着”prog” 鈕不放，直至…
2. 機身面板的”mute” 鈕亮着，本功能 -- Unity Gain(AV Bypass) 被選用。
3. 倘若本功能未能選用，可以按相同按鈕(試”mute” 或”In 4 AV”)兩次來啟動。
故此你需要一條DIN>>RCA接線。
師兄恭喜晒{:6_193:}{:6_193:}
{:6_195:}
有無相睇呀?
由xs直上2系當然係兩個唔同境界啦, 玩到2系仲有冇機疊機呀?
