想問我用 AV AMP 看 MOVIE 時, 將 1 對 RCA 入 202 AUX2, 點先可以自動 BYPASS 看 MOVIE 呢?
Jackiewakusome 發表於 2011-5-5 23:54
28 Preamplifier and Integrated Amplifier Operation
Many operational and control features of Naim preamplifiers and integrated amplifiers are common to all and are based on a similar user interface. This section of the manual describes those features and the user interface, drawing attention to differences between products where they occur. Table 28.10 sets out some variations in user interface between products.
Front panel controls are duplicated on the remote control handset which may also provide some extra functions. See Sections 29 and 30 for more information.
For the purposes of brevity the term preamplifier in the following paragraphs can be taken also to mean integrated amplifier.
28.2 AV Integration (Unity Gain)
Unity Gain enables an audio-visual processor to be integrated such that its volume control takes over command of signals connected to selected preamplifier inputs. On the NAC 552 Unity Gain may be selected on DIN input sockets 4 and 5. On all other preamplifiers it may be selected on only the av input.
1. To select Unity Gain, first switch the preamplifier into program mode by pressing and holding the handset prog key (with the handset in preamplifier mode).
2. The front panel source mute button (NAC 202 mute button, NAC 152 XS and Nait 5i av button) will illuminate if Unity Gain is selected.
3. If it is not enabled it can be switched on by pressing the same button twice.
See table 28.10.
Unity Gain only becomes operational on exit from program mode by pressing and holding the handset prog key.
Note: The preamplifier will leave program mode automatically if no control commands are received for five minutes.
[複製鏈接]
發表於 2011-5-6 00:09
