条 XLR > DIN (5 PIN) 线终于搞掂喇!!!

PP-HK

冇理由會差左, 我以前都係av amp 用rca pre out去naim5i, 升左級之後av amp rca to din去122, d聲冇受影響。

你呢條線係秋記造, 應該就係我用緊係3.5 to din果條, 我用來插ipod去122, d聲唔錯架。

Jackiewakusome

回復 9# yeungone


條線有D問題? The cable is Made In Germany, maybe its too narrow?
線材 μf 值唔正確? What is μf 值?
焊接得唔好? Should be OK

Actually I dont know much about cable......

Jackiewakusome

回復 10# Big_McIn

Hi buddy,

Thanks again for your great help!

+++++++++++++++++++++++++++++++++++
唔知你用乜AV Processor，正常XS NAIT 上202+200無理由差咗。<---I am using Onkyo 5507

因合併和前後級靈敏度不同，以前接XS NAIT用乜接？怎樣接？<---I used XLR > RCA on my NAIM NAIT XS b4. The sound was great!!!

RCA/XLR  和 DIN/XLR原理一樣，只不過一粒DIN = 两粒RCA。<---I see

AV Setting要重新再做。<--- I at the very beginning used RCA > RCA from 5507 to NAIT XS. Result was good. Then changed to XLR > RCA to my NAIT XS, whithout any re-setting, result was better. Then now changed to XLR > DIN because of my 202, 200 AV Bypass, however, result is not good, bass is less, not so powerful, I dont know why. Maybe I need to use the original NAIM RCA > DIN cable for best result?

I wanna know after changed to 202, 200, the result should be better, right? Louder? More powerful? More detail?

Jackiewakusome

回復 11# PP-HK

Hi pal,

升左級之後av amp rca to din去122, d聲冇受影響。<----d聲冇受影響? You mean no difference?

你呢條線係秋記造, 應該就係我用緊係3.5 to din果條, 我用來插ipod去122, d聲唔錯架。<----my cable is Made in Germany, HK$20/foot, grey, quite narrow.

PP-HK

用係AV度d聲變化不大, 當然2 channel就完全係兩個境界。條線加左咁多價呀, 我果時好似係10/呎。

Jackiewakusome

我最後用返 NAIM 條原裝 2RCA > 5DIN 條 CABLE.

感覺:

1) D BASS 好重好實, 我好 LIKE, 聽 T4 D 配樂 D BASS 好勁好沉實, 聽 RAMBO 4 主角用箭殺人果段, 當 D 箭插落人個身時好有力, D BASS 好0岩聽, 同之前無0西 BASS 真係兩個世界

2) RAMBO 4 主角用刀斬頭時, D 刀0既金屬聲同回音, 我好 LIKE

3) 看冬蔭公 DVD 時, MENU 0既背景音樂 D BASS 而家返返0黎喇

之前唸住平, 用 $500 做條 DIY XLR > DIN, 點知兜兜轉轉又係用返 NAIM 原廠線. 其實前置對電影效果都好緊要, 可以將成個音場帶起呀

Big_McIn

Then now changed to XLR > DIN because of my 202, 200 AV Bypass, however, result is not good, bass is less, not so powerful, I dont know why. Maybe I need to use the original NAIM RCA > DIN cable for best result?
...
Jackiewakusome 發表於 2011-5-13 17:53

可能性：

秋記亞姐搞錯+ve x 2 和 -ve x 1與XLR (+) (-) (G)的關係。

其實DIN只有5針，可以原裝線作比對，check check +ve, Ch1 In(L),-ve, Ch2 In(R), +ve各針與L/R RCA插關係，然後改駁上XLR，亦可買两粒RCA>>XLR Adapter來跟正腳位，最大機會出錯是+ve和-ve。

否則就是DIN >> XLR 和 DIN >> RCA Impedance不同，咁就無得搞。

不過，5507並非行balance設計，只內置unbalance >> Balance切換線路板，既然Naim不設Balance IN，只用DIN，RCA出再入DIN重直接哩。

Jackiewakusome

回復 17# Big_McIn


    hi pal,

Yeah, I have asked Michael's Audio, they said maybe the master in Akihabara has reversed the +ve or -ve. Anyway, my problems have been solved, thanks again for your comprehensive explanation!

ivanyiu

我好想知條 XLR -> DIN 整左幾錢?

Jackiewakusome

回復 19# ivanyiu


    唔记得喇，$3XX.

你有无兴趣？