Parasound 5250 v.2 新版五聲道後級 (轉載)

lippito

同舊版有乜分別？

avlam

到時出街就未必係呢個價啦!!!

Big_McIn

同舊版有乜分別？
lippito 發表於 2011-3-1 01:30

肉眼睇到：

1. 個嘜頭。
2. 面版和機背鐵手柄。
3. 機背標明Power Consumption 1800w，與A51一樣，但Spec又話2500w；舊款標明2500w，是否暗示两隻環牛????
4. 機背五粒聲道volume調較制，Auto on/off和Ground Lift。

舊款街價都係賣成HK$19~20K喎，雖然佢話二萬係人仔，折合港幣就要成HK$24K，打個八八折就成HK$21K，Halo Series唔轉款加大價，5250改改加仟零二仟哩。


5250 vs 5250 V.2









5250
Continuous RMS Power Output
    20 Hz - 20 kHz, Five Channels Driven
    250 watts x 5, 8 Ω
    385 watts x 5, 4 Ω
Current Capacity
    45 amps peak per channel
Frequency Response
    20 Hz - 50 kHz, +0/-3 dB, 1 watt
Dynamic Headroom
    1.6 dB
Total Harmonic Distortion
    0.025% at full rated output
    0.02% at average listening levels
IM Distortion
    0.05 %
Transient IM Distortion
    Not measurable
S/N Ratio
    114 dB at rated output, IHF A-weighted
    106 dB at rated output, unweighted
    93 dB at 2.828 V output, IHF A-weighted
    84 dB at 2.828 V output, unweighted
Input Impedance
    33 k Ω
Input Sensitivity
    1 V in for 28.28 V out, THX standard
    1.6 V for full rated output
Inter-Channel Crosstalk
    85 dB, 1 kHz
    73 dB, 10 kHz
    67 dB, 20 kHz
Damping Factor
    Over 150 at 20 Hz
    Auto Turn On - DC
    9 - 12V, 15 mA
Auto Turn On - Audio
    1.2 mV - 12 V, adjustable
    15 minute turn off delay
AC Power Requirement
    110 - 120 V / 220 -240 V, 50 - 60 Hz
    3 watts standby; 2500 watts full output
Dimensions
    17-1/4" Wide
    18-1/2" Deep with connectors
    7-5/8" High with feet, 7" panel only
    437 x 470 x 193mm, 176mm panel only
Net Weight
    69 lbs., 31.4 kg
Rack Mount Accessory
    May be Purchased Separately
    RMK44


5250 V.2
Continuous RMS Power Output
    20 Hz - 20 kHz, Five Channels Driven
    250 watts x 5, 8 Ω
    385 watts x 5, 4 Ω
Current Capacity
    45 amps peak per channel
Frequency Response
    20 Hz - 50 kHz, +0/-3 dB, 1 watt
Dynamic Headroom
    1.6 dB
Total Harmonic Distortion
    0.025% at full rated output
    0.02% at average listening levels
IM Distortion
    0.05 %
Transient IM Distortion
    Not measurable
S/N Ratio
    114 dB at rated output, IHF A-weighted
    106 dB at rated output, unweighted
    93 dB at 2.828 V output, IHF A-weighted
    84 dB at 2.828 V output, unweighted
Input Impedance
    33 k Ω
Input Sensitivity
    1 V in for 28.28 V out, THX reference level
    1.6 V for full rated output, adjustable from 500mV to 5
Inter-Channel Crosstalk
    85 dB, 1 kHz
    73 dB, 10 kHz
    67 dB, 20 kHz
Damping Factor
    Over 150 at 20 Hz
Auto Turn On - DC
    9 - 12V, 15 mA
Auto Turn On - Audio
    1 mV sensitivity
    15 minute turn off delay
AC Power Requirement
    110 - 120 V / 220 -240 V, 50 - 60 Hz
    1 watt standby; 2500 watts full output
Dimensions
    17-1/4" Wide
    19" Deep with gain control knobs
    7-5/8" High with feet, 7" panel only
    437 x 482 x 193mm, 176mm panel only
Net Weight
    69 lbs., 31.4 kg
Rack Mount Accessory
    May be Purchased Separately
    RMK44


輸出和體重都一樣。利用訊号Auto on/off功能簡化咗，Ground Lift改善Ground Loop Hum又無咗，五聲道音量獨立調節，即係五只香爐，就是這樣都足夠有60點改動，不過，無仲好呀，Parasound。

JamesK

樓主, 有冇 "肉照" 睇睇 ? Thanks!

Big_McIn

樓主, 有冇 "肉照" 睇睇 ? Thanks!
JamesK 發表於 2011-3-1 09:09

5250呢道有得睇，V.2就現在唔好冀望住

peter99

流晒口水
fuman0123 發表於 2011-2-28 22:57

    文老闆：買啦買啦...

fuman0123

回復 16# peter99


    Peter哥………我只不過係打功仔一名，重係低收入人士
我現時只係望下張相都好開心架啦！

Jackiewakusome

Can it be MIU?

Big_McIn

Can it be MIU?
Jackiewakusome 發表於 2011-3-1 11:36

Thirty years ago, the upstart audio company NAD revolutionized the manufacturing of consumer-electronics components by "internationalizing" the process. Instead of physically making products, NAD hired a project team in one location to design a product that was then built at a sub-contracted factory located elsewhere. The arrangement allowed NAD to go into business with relatively little capital outlay and low overhead. Other companies have since copied this ingenious business model, and, as transportation and communication have improved, doing so has become easier and more efficient. It has brought prices down and quality up—mostly in the low and middle segments of the high-end audio and video markets.
I haven't studied San Francisco-based Parasound Products' business or its books, but the NAD model has clearly been an influence on Parasound, which was founded in 1982. The Parasound Halo JC 1—a powerful, sophisticated premium product—was designed by a team headed by audio legend John Curl, and built for Parasound by a factory in Taiwan. It takes the outsourcing concept way upscale while keeping the amplifier's price down to a remarkable $3000 each. The 5-to-1 ratio of cost to retail price that is the norm in the audio industry suggests that the "raw" cost of the JC 1 is about $600—a number almost impossible to believe, given the superb build quality and sheer heft of this powerhouse monoblock.


http://www.stereophile.com/solidpoweramps/774/

CrazyBull

回復  peter99


    Peter哥………我只不過係打功仔一名，重係低收入人士
我現時只係望下張相 ...
fuman0123 發表於 1/3/2011 10:52 AM

Fuman兄你睇完可以開心到都算好，我睇完就好吾開心