CM8 和 CM7 嘅選擇？

kwchan

Int. Amp,  如果考慮Luxman 505u or Naim XS, 邊部比較夾CM7?

lippito

我都想知金仔、Luxman 同 Naim 邊隻聲底夾 CM 多 D，鎖定目標就食樹根儲錢，加多聲道後級計劃暫時擱置！

avlam

Naim 同 B&W嘅特性有啲相同,咁金仔同Luxman應該會夾啲!!

avlam

Int. Amp,  如果考慮Luxman 505u or Naim XS, 邊部比較夾CM7?
kwchan 發表於 2011-1-14 09:16

就505U啦!!

liclic

想問下加power amp (e.g. 8ohm 250W) 推CM5 8 ohm 120W, 個power amp會唔會整壞個 cm5?

如果已經有int amp 加power amp, 用bi-amp or pre-out to power amp?

chiuching

想問下加power amp (e.g. 8ohm 250W) 推CM5 8 ohm 120W, 個power amp會唔會整壞個 cm5?

如果已經有int amp ...
liclic 發表於 2011-1-14 14:34

一定會整壞~ 但係你對耳爆先!

Big_McIn

M2目前沒有Power Amp, 可能未來會有, M1現在就有
ANWKLO 發表於 2011-1-14 08:12

Roksan K2 Integrated Amp 輸出
Output Power >125 Watts, into 8 Ohms
both channels driven
190 Watts, into 4 Ohms

和K2 Power amp輸出
Output Power >125 Watts, into 8Ω
both channels driven
200 Watts, into 4Ω
都有少少分別，廠方亦建議K2 Integarted + K2 Power Amp來玩Bi-amp。

Roksan M2和Caspian M1的Specifications非常接近，其中Pre Amplifier和Power Amplifier的gain完全一樣。
M2 Integrated Amplifier:
Output Voltage 240mV (Tape Out)
700mV (Pre Out)  
Power Outputs Loudspeaker, L & R
Output Power 85 Watts, into 8Ω both channels driven
125 Watts, into 4Ω both channels driven  
Power Supply 350VA Ultra Low Noise Toroidal Transformer
60VA Ultra Low Noise Transformer Preamp Section Toroidal
5 Regulated Supply Rails  
Current Output 60 Amps Peak to Peak
Damping Factor 160 (8)Ω
Frequency Response -3dB, <1Hz – 90kHz
Gain 40dB Overall (Pre & Power)
9.3dB Preamplifier
30.7dB Power Amplifier  
Caspian Integrated Amplifier (M series-1)
Output Voltage 240mV (Tape Out)
700mV (Pre Out)
Power Outputs Loudspeaker, L & R
Output Power 85 Watts, into 8Ω
both channels driven
120 Watts, into 4Ω
both channels driven
Power Supply 350VA Ultra Low Noise Toroidal Transformer
4 Regulated Supply Rails
Current Output 50 Amps Peak to Peak
Damping Factor >140 (8Ω)
Frequency Response -3dB, <1Hz – 90kHz
Gain 40dB Overall (Pre & Power)
9.3dB Preamplifier
30.7dB Power Amplifier
Caspian Stereo Power Amplifier (M series -1)
Output Power 85 Watts continuous, into 8Ω
both channels driven
120 Watts continuous, into 4Ω

Roksan M2 Integrated Amp + Caspian Stereo Power Amp 來玩Bi-amp又那有問題呢？

玩Bi-amp最完美當然是Pre Amp + Stereo Power Amp x 2，Intergrated Amp + Stereo Power Amp始終在電源供應裏都有分別。

Big_McIn

想問下加power amp (e.g. 8ohm 250W) 推CM5 8 ohm 120W, 個power amp會唔會整壞個 cm5?

如果已經有int amp ...
liclic 發表於 2011-1-14 14:34

本人 B&W 802D是：
Recommended amplifier power 50W – 500W into 8Ω on unclipped programme
用PassLab X600.5  output 600w Mono
爆到七彩都無事：

CM 5
Recommended amplifier power 30W - 120W into 8Ω on unclipped programme
用高質素Amp 250w/ ch例如 MF A5.5完全無問題，Recommended amplifier power 數據可以不理。

如果已經有int amp 加power amp, 用bi-amp or pre-out to power amp?
用Roksan K2 Int. Amp + K2 Power Amp才可玩Bi-amp，不同牌子就唔妥哩。

ANWKLO

Roksan M2 Integrated Amp + Caspian Stereo Power Amp 來玩Bi-amp又那有問題呢？

玩Bi-amp最完美當然是Pre Amp + Stereo Power Amp x 2，Intergrated Amp + Stereo Power Amp始終在電源供應裏都有分別。
Big_McIn 發表於 2011-1-14 21:32

"Roksan M2 Integrated Amp + Caspian Stereo Power Amp 來玩Bi-amp", 都無話唔得,  M1同M2 聲音取向唔同, 只係音色上的問題, 唔係個gain同power問題. 況且Roskan 講了遲些會出 M2 Stereo Power Amp

玩Bi-amp唔單只最完美是Pre Amp + Stereo Power Amp x 2, 重有Pre Amp + Mono Power Amp x 2 啦     最完美當然重有Pre Amp + Mono Power Amp x X

米赫洛域

"Roksan M2 Integrated Amp + Caspian Stereo Power Amp 來玩Bi-amp", 都無話唔得,  M1同M2 聲音取向唔同 ...
ANWKLO 發表於 2011-1-14 22:06

好似小弟咁用m2尼推對cheap cheap書架夠晒架喇，再加power amp就得師兄d高人玩啦！