新加入696 想問 firmware update 注意事項

yeye696

新加入696家庭

機身顯示的 firmware 為  R106-0202-1010-0024

Onkyo 官網 於  2020-03-12  更新左為 ： R115-0505-1130-0028

已將數據下載在PC harddisk 且已解壓

想用 USB 做 update

由於第一次做  有點擔心  英文理解力一般  特意向各師兄姐請教

■ Update via USB storage
Please prepare a USB storage device such as a USB flash
memory stick. You need at least 32 MB of available
space to update the firmware.

Note
• Check the network connection before updating.
• Do not touch any cable or device connected to the AV receiver
during the update process.
• Do not attempt to access the AV receiver from your PC while it
is being updated.
• Do not shutdown the power of the AV receiver while it is being
updated.
• The storage media in the USB card reader may not work.
• If the USB device is partitioned, each section will be treated as an
independent device.
• If the USB device contains a lot of data, the AV receiver may take
a while to read it.
• Operation is not guaranteed for all USB devices, which includes
the ability to power them.
• Onkyo takes no responsibility whatsoever for the loss or damage
of data resulting from the use of a USB device with the AV
receiver. Onkyo recommends that you back up your important
music files beforehand.
• If you connect a USB hard disk drive to the USB port, Onkyo
recommends that you use its AC adapter to power it.
• USB hubs and USB devices with hub functions are not supported.
Do not connect your USB device via a USB hub.
• USB devices with security functions are not supported.

多謝指教  感激

Dan0412

yeye696你好,

請通過電腦到以下網址下載升級軟體/Firmware.
https://www.intl.onkyo.com/support/firmware/tx-nr696.html

安裝升級軟體步驟如下:
1. 請先解壓已下載之升級軟體/Firmware, 然後將軟體/Firmware放在已格式化的USB記憶棒內.
2. 在待機狀態下, 插入已存有升級軟體之USB記憶棒在TX-NR696機背後的USB插座, 然後開機及等待3分鐘.
3.  按"Setup", 在Setup Manu中選擇 "Miscellaneous".
4.  選擇 "Firmware Update" 然後再選 “Update Via USB" 再按enter.
5.  請等候二至三十分鐘, 直至機前面顯示屏出現"Completed” 代表升級成功完成.
(請勿在升級過程中關掉電源及按下前面板按掣)

希望以上資料可以幫到你!

Dan1

yeye696

Dan0412 發表於 2020-3-16 16:29
yeye696你好,

請通過電腦到以下網址下載升級軟體/Firmware.

多謝 Dan0412 師兄的說明  已順利解決  及  安裝新的 firmware

謝謝幫忙