Since the 8Q has auto-EQ feature, I will prefer to run it first to setup sw's own eq and then use the AV Amp's Audyssey to detect the optimum settings for all the speakers.
quoted from manual:
EQ — This button automatically equalizes the subwoofer’s output so that it sounds best for its position in the room. To use this feature, remove the grille and plug the supplied microphone into the Mic-In jack on the front baffle of the sub and place the mic in your preferred listening position. Then press EQ on the remote for about 2-3 seconds. The subwoofer emits 12 “sweep tones” that span the frequencies between 20 and 150 Hz. The LED displays “AU” during the Auto-EQ process. After the sweeps are complete, the unit saves its EQ settings and returns to normal operation. To prevent accidental invocation of the EQ feature, you must hold down the EQ button for 2-3 seconds before the EQ sweeps begin. If the mic is not plugged in, the subwoofer sweeps twice then reverts back to normal functioning without changing any EQ settings.
發表於 2009-5-5 13:44
樓主
