十仔 setting 問題
本帖最後由 wil-wil 於 2009-5-28 03:16 編輯我想問下 個十仔 果個 low pass crossover 應該點set，我唔識 (本人係新手)~我想用佢個 auto setting. 咁個制仲要唔要 set 架?
請指教! set by-pass 係咪即係 direct ? 係咪即係 direct ?
tontontony 發表於 2009-5-5 14:01 http://www.post76.com/discuss/images/common/back.gif
是{:6_182:} 多謝指教! 咁另外請問 set auto 係應該 個 十仔自己set auto 一次 還是 av amp set auto 一次就已經ok呢? 咁另外請問 set auto 係應該 個 十仔自己set auto 一次 還是 av amp set auto 一次就已經ok呢?
tontontony 發表於 2009-5-5 14:05 http://www.post76.com/discuss/images/common/back.gif
First do the EQ setup from your subwoofer first, then run auto-setup from your AV AMP. 一般用AV Amp 嘅 Audyssey auto detect.
請問Ching 用什麼牌子/Model 的subwoofer{:1_342:} AV AMP - 706
SUB - 威力登 CHT 8Q
多多指教! 本帖最後由 ikkjr 於 2009-5-5 17:29 編輯
Since the 8Q has auto-EQ feature, I will prefer to run it first to setup sw's own eq and then use the AV Amp's Audyssey to detect the optimum settings for all the speakers.
quoted from manual:
EQ — This button automatically equalizes the subwoofer’s output so that it sounds best for its position in the room. To use this feature, remove the grille and plug the supplied microphone into the Mic-In jack on the front baffle of the sub and place the mic in your preferred listening position. Then press EQ on the remote for about 2-3 seconds. The subwoofer emits 12 “sweep tones” that span the frequencies between 20 and 150 Hz. The LED displays “AU” during the Auto-EQ process. After the sweeps are complete, the unit saves its EQ settings and returns to normal operation. To prevent accidental invocation of the EQ feature, you must hold down the EQ button for 2-3 seconds before the EQ sweeps begin. If the mic is not plugged in, the subwoofer sweeps twice then reverts back to normal functioning without changing any EQ settings.
頁:
[1]
2