Firmware Update Steps:
1. Unzip the downloaded file into the root directory of a USB thumb drive
2. Plug the USB thumb drive into USB port of VTEN/VTEN-U
3. Access to Setup->Maintenance in UI
4. Select Firmware Update and press Enter on the "Check For Firmware Update" button
5. If the file v10-update.bin/v10u-update.bin is found in the USB thumb drive, it will prompt for firmware update
Release Notes:
- Added support for multi-channels ALAC codec (M4A). Note: Gapless playback and ID3 support will implement later.
- Fixed PGS sometimes display too fast
- Fixed some FLAC skip few seconds during gapless transition
- Fixed WAV 3, 4, 5 and 7.1 channels unable to start playback issue
- Changed LPCM 3 channels layout from 2.1 to 3.0
- Fixed BDMV/BDISO, M2TS, TS unable to auto stop playback or repeat after finish issue