Marantz SR6003 接駁 3D Blu-ray 問題

kapo

All CHings, I have the following AV equipment:

1. Marantz SR6003
2. Panasonic 3D Plasma TV TH-P42GT20H
3. Panasonic 3D Blu-ray player DMP BDT-300, which has two HDMI output ports.

Since Marantz SR6003 doesn't have HDMI 1.4 and thus doesn't support 3D video signal, I have to connect the first HDMI output from the blu-ray player to TV directly for video, and another HDMI to amp for audio.

Blu-ray player HDMI 1 ==> TV
Blu-ray player HDMI 2 ==> SR6003 (HDMI 3, assigned to DSS of the amp)

Note: The blu-ray player will not output video signal from its HDMI2 port. There is only audio signal from its HDMI2.

Now I can watch 3D picture from Blu-ray player on TV.
But the sound cannot come out automatically from speakers.
Front display of Marantz shows "NO DATA" only.
When I press the "setup" button on the amp's remote control to enter the setup mode, SR6003 can detect the DTS-HD MA sound from the blu-ray player and there is sound.

However, when I press "exit" to leave the setup mode, again "NO DATA".
HDMI Audio is set to "enabled", not "through".

What else I need to set in order for SR6003 to detect and play the sound automatically without going into the setup mode everytime?
Please help! Thanks a lot!