Help on projector installation

ikkjr

Thank you finally someone understood my poor English, SSP here I come then!
breadvan 發表於 2012-1-5 13:25

You're most welcome & hope you can find the suitable mount in SSP

breadvan

回復 11# ikkjr

Hi ikkjr, I just went to SSP, although there were mounts, the quality was in general not very confident inspiring, so I will think of other ways to do it.  Again, thanks.

ikkjr

回復 12# breadvan
You can take a look at Vogel's products if budget is not a big concern.

http://www.vogels.com/web/Profes ... mp;typeofpage=81807

breadvan

回復 13# ikkjr

Thanks but the issue is I only needed the mount arms and the arms have to have screw holes 8 inches apart which are very hard to find. If I needed the whole mount I certainly would not mind looking the Vogel ones. I have made some thick acrylic board like what racing has done here and give it a try, fingers crossed, again, thank you.