kaiyau
發表於 2010-8-6 11:42
您可以排定想優先使用哪些揚聲器。
注意
• 如果「Sp Type」設置為「Bi-Amp」(➔ 40),或使用有
...
maner394 發表於 2010-8-6 11:38 http://www.post76.com/discuss/images/common/back.gif
Thx!!
雖然小弟係新手,對影音方面既知識領悟力亦較低,不過我都會繼續鑽研下的。
babuwa
發表於 2010-8-6 12:41
How it's sound now for two micropod in series? since it's 4 ohm, it should be OK, If you worry about this, try to use one micropod only since it's good enough if your room is not too big.
kaiyau
發表於 2010-8-7 10:20
How it's sound now for two micropod in series? since it's 4 ohm, it should be OK, If you worry about ...
babuwa 發表於 2010-8-6 12:41 http://www.post76.com/discuss/images/common/back.gif
轉回用左一個micropod做中置後,聲音好似細左好多......感覺用兩個micropod轉順耳.
不過用兩個,我擔心唔知有咩唔好既後果...{:6_201:}
babuwa
發表於 2010-8-8 02:10
本帖最後由 babuwa 於 2010-8-8 02:14 編輯
轉回用左一個micropod做中置後,聲音好似細左好多......感覺用兩個micropod轉順耳.
不過用兩個,我擔 ...
kaiyau 發表於 2010-8-7 10:20 http://www.post76.com/discuss/images/common/back.gif
Should not be big problem, since your speaker is 4 ohm, which was better for your amp when you use two speaker in serial (8 ohm) as less current draw from amp. amp loading were less.
but when you change to one center speaker, have you do auto-calibration again? since the volume inside the amp will be auto adjust if you do auto calibration, Is that due to you just change to one center but havn't calibrate? so 聲音好似細左好多?
kaiyau
發表於 2010-8-8 13:37
Should not be big problem, since your speaker is 4 ohm, which was better for your amp when yo ...
babuwa 發表於 2010-8-8 02:10 http://www.post76.com/discuss/images/common/back.gif
等我試試先!!謝謝師兄解釋,很好..{:6_195:}