請教7.1
本帖最後由 MadMad@G 於 2021-6-5 02:43 編輯請教7.1
我有反射喇叭 但無反應 是否不支援7.1？
amp 用緊lx904 ，藍光機用sony ux700，藍光碟支援7.1
謝謝回覆 試試喺碟機果面嘅sound output set做bitstream 唔應該set 7.1 應該set 5.1.2 7.1ch係冇反射喇叭（ATMOS)訊號 老五 發表於 2021-6-5 12:09
唔應該set 7.1 應該set 5.1.2
試過唔得 AskaLung@FB 發表於 2021-6-5 12:21
7.1ch係冇反射喇叭（ATMOS)訊號
藍光機咁5.1正常？ 我選擇唔用amp auto 就會出現 MadMad@G 發表於 2021-6-5 12:46
試過唔得
唔得係乜野意思，我都係904用家，我set7.1.2 老五 發表於 2021-6-5 13:20
唔得係乜野意思，我都係904用家，我set7.1.2
師兄 你睇7.1用amp auto 都出到8個格仔？ 不如你睇下碟機有冇set 錯野啦~
正常做定位時d喇叭全部出到聲就冇問題。 本帖最後由 allen89 於 2021-6-5 14:34 編輯
你的相片顯示仍PCM輸入，回覆2師兄已提你
看看sony player 內digital Audio output是否已經設置在auto
如聲晝兩hdmi分家，secondary audio 設置on
用反射喇叭兩隻是5.1.2如圖回覆#3師兄建議正確
以下
sony 說明書
x
: Normally select this. Outputs audio
signals according to the status of the
connected devices.
: Outputs PCM signals from the DIGITAL
OUT (COAXIAL)/HDMI OUT jack. Select this if
there is no output from the connected device.
x
: Outputs DSD signal from HDMI OUT
jack when playing Super Audio CD & DSD
format file (if the connected device also
supports DSD).
Outputs LPCM signal from HDMI OUT jack
when playing Super Audio CD & DSD format
file (if the connected device does not support
DSD).
: Outputs PCM signals from HDMI OUT
jack when playing Super Audio CD and DSD
format file.
x
: Outputs the audio obtained by mixing
the interactive and secondary audio to the
primary audio.
: Outputs the primary audio only. Select
this to output Bitstream (Dolby/DTS) signals
to an AV amplifier (receiver).
z
To enjoy Bitstream (Dolby/DTS) signals, set [BD
Secondary Audio] to and [Digital Audio
Output] to .
頁:
[1]
2