laiho
發表於 2015-12-29 09:04
sccyan 發表於 2015-12-29 08:34 static/image/common/back.gif
正呀Ching,恭喜晒如果配到條PS電源線效果應該會更好
(Post76 Android 手機版送出) ...
我都想,但兩間都話PS電源線依家唔出口所以冇晒貨{:8_365:}
mmmclll
發表於 2015-12-30 11:53
Ching, 可否pm拖版價錢?Thanks
sccyan
發表於 2016-1-4 15:38
本帖最後由 sccyan 於 2016-1-4 15:58 編輯
laiho 發表於 2015-12-29 09:04 static/image/common/back.gif
我都想,但兩間都話PS電源線依家唔出口所以冇晒貨
係呀Ching, 我都係嗰日上威達諗住碰一碰運氣睇下仲有無PS電源線,点知仲有最後一條AC-10, 咁就買左喇,真係好好彩{:6_143:}另外,Amazon UK仲有英式頭 PS AC-3賣,香港有集運公司可由UK代收寄到香港,運費唔貴,你睇下啱唔啱啦{:6_196:}
(Post76 Android 手機版送出)
laiho
發表於 2016-1-4 21:11
多謝ching提供資料,因小弟家貧暫時都唔考慮了.....{:8_374:}
另外今朝起身發覺插在拖板的器材冇電到,開關不停閃,我再按開關掣後才正常通電
當時是十個位全插滿的,ching有試過這情況嗎?請問是什麼問題?
sccyan
發表於 2016-1-5 09:56
laiho 發表於 2016-1-4 21:11 static/image/common/back.gif
多謝ching提供資料,因小弟家貧暫時都唔考慮了.....
另外今朝起身發覺插在拖板的器材冇電到,開關不 ...
{:6_121:}{:6_121:}我都係插滿10個位,但未試過有你這種情況出現過喎{:6_240:}
(Post76 Android 手機版送出)
小寶老豆
發表於 2016-1-5 10:42
本帖最後由 小寶老豆 於 2016-1-5 10:46 編輯
laiho 發表於 2016-1-4 21:11 static/image/common/back.gif
多謝ching提供資料,因小弟家貧暫時都唔考慮了.....
另外今朝起身發覺插在拖板的器材冇電到,開關不 ...
{:6_146:} ... 師兄, 唔好怪我多事...
換新電器嘢, 最緊要最緊要最緊要最緊要最緊要最緊要係睇說明書先....
http://www.psaudio.com/wp-content/uploads/2014/11/Dectet-Owners-Manual-V3-Rev-B.pdf
Blinking logo light
A fast blinking logo power button means there is an over or under voltage situation and the unit has shut off. This occurs when greater than 20% of the rated voltage is exceeded or if the voltage is below 25% of the rating. The Power Center should automatically turn back on when the voltage on the line has returned to normal. If it does not, simply press the logo power button to reactivate the Power Center.
If the power light blinks
If the logo light fl ashes quickly (~5 per second), it means the voltage has exceeded 125 (250) on the high side or dropped below 105 (210) volts on the low side. The blinking only indicates a potential problem. There is no harm in running most equipment at these higher and lower voltages.
Fast blinking vs. Slow blinking
If the logo power light button flashes slowly (~2 per second) and the Dectet will not power on it means the MOV protection inside the Dectet has failed due to a heavy surge or spike. Failure of the MOV means the MOV protection device has served its purpose by protecting your equipment and it then shuts off the Dectet in order to continue protecting your connected equipment In the rare event this should take place, the unit will require servicing to replace the MOV protection if your connected equipment is to remain safely protected from potentially damaging surges and spikes.
If you wish to temporarily disable the auto shutdown process until you can remove the Dectet and get it repaired, you can hold down the PS logo power button for 3 seconds which will reset the auto shutdown commands. While there is no problem in disabling this protection state, you should be aware that your connected equipment is no longer protected from surges and spikes. Over and under rated voltage conditions will be protected against.
laiho
發表於 2016-1-5 11:12
小寶老豆 發表於 2016-1-5 10:42 static/image/common/back.gif
... 師兄, 唔好怪我多事...
換新電器嘢, 最緊要最緊要最緊要最緊要最緊要最緊要係睇說明書先.. ...
多謝ching提供資料,但唔係幾睇得明...{:6_136:}
原因是否插了電壓偏高/偏低的電器?因為之前我插了老爺PS3
電源線不是原裝,不知是否這關係?
小寶老豆
發表於 2016-1-5 11:28
laiho 發表於 2016-1-5 11:12 static/image/common/back.gif
多謝ching提供資料,但唔係幾睇得明...
原因是否插了電壓偏高/偏低的電器?因為之前我插了老爺PS ...
{:6_229:}
Ching, should like this...
The Dectet will measure the incoming AC to be certain it is at an acceptable level, which is +20% to -25% of the design voltage.
sccyan
發表於 2016-1-6 21:36
laiho 發表於 2016-1-4 21:11 static/image/common/back.gif
多謝ching提供資料,因小弟家貧暫時都唔考慮了.....
另外今朝起身發覺插在拖板的器材冇電到,開關不 ...
哈哈Ching,呢頭講完到我當日有同樣問題出現{:6_212:}{:6_212:}
(Post76 Android 手機版送出)
laiho
發表於 2016-1-6 23:44
sccyan 發表於 2016-1-6 21:36 static/image/common/back.gif
哈哈Ching,呢頭講完到我當日有同樣問題出現
(Post76 Android 手機版送出) ...
呢d野都會傳染?咁之前有冇插過d特別野呢?{:6_175:}