唔識嘢請指教
本帖最後由 tnak 於 2014-4-3 23:04 編輯膽機擺喺個倉到幾年都冇用過。
手痕行的返屋企試吓。
插座電源之後完全唔着。
小弟啱啱入門玩cas. 想試吓玩膽機
睇下有咩唔同組合。
乜都試吓。
Ching 大佬可以解釋一下嗎?{:9_419:} 本帖最後由 billymud 於 2014-4-4 02:18 編輯
拔走電源線， 檢查灰士？
師兄件野好特色，有機會影下內部look look 嗎？{:6_195:} billymud 發表於 2014-4-4 02:11 static/image/common/back.gif
拔走電源線， 檢查灰士？
已check FUSE 冇斷,
隻膽正確嗎?
我見D其他相有大有細,
開機要等一等,e幾日比較忙
thx
本帖最後由 billymud 於 2014-4-4 15:52 編輯
tnak 發表於 2014-4-4 15:23 static/image/common/back.gif
已check FUSE 冇斷,
隻膽正確嗎?
我見D其他相有大有細,
"隻膽正確嗎? " -- this's a good question!and that's the reason for my request of a "OPEN VIEW" of ur antique.{:1_351:}
it appears two rectifier tubes were (or to be) installed.Or, that tube was wrongly located .......Oop~~,as u said"FUSE 冇斷,.....見D其他相有大有細,..." {:1_339:}
billymud 發表於 2014-4-4 15:31 static/image/common/back.gif
"隻膽正確嗎? " -- this's a good question!and that's the reason for my request of a "OPEN VIEW" ...
兩隻膽係一樣.
我指大細係見到其它機通常裝4大2細膽
個座有個凹凸位同隻膽一樣,得一個位可以裝上去
thx
it
本帖最後由 billymud 於 2014-4-5 00:54 編輯tnak 發表於 2014-4-4 23:47 static/image/common/back.gif
兩隻膽係一樣.
我指大細係見到其它機通常裝4大2細膽
個座有個凹凸位同隻膽一樣,得一個位可以裝上去
兩隻膽係一樣..... I can't tell more, until u show the "OPEN VIEW" of the unit.
其它機通常裝4大2細膽..... those 係integrate/pwr amplifier, not the type of yours. (see pic below).YOURS is a pre-amp.
個座有個凹凸位同隻膽一樣,得一個位可以裝上去.... that's fool-proof for orientation.it doesn't prevent u from installing the WRONG tube(s). {:1_339:}
may be, yes may be...... the right tubes are 6sn7.hv u ?? {:1_331:}
stop installing any tubes.....{:1_330:}
consult ADA c_hing or zoneaudio c_hing at ur convenience la~~ {:1_262:}
http://post76.hk/forum.php?mod=forumdisplay&fid=84
5v4g是整流膽，
師兄內外影個全相吧 本帖最後由 ADA 於 2014-4-6 11:54 編輯
都係果句, 影張開底蓋相看看就清楚了.
如果樓主你肯定這2支膽係這部機用就一定係左右位問題,
但因為這2支膽的特性及接腳是完全不同的, 所以最好唔好再通電試了.
亦有可能5V4G不是這機用的, 見你部機後面有2組輸入輸出, 又有粒拍拍掣,又有獨立VR,
...這組合比較奇怪, 以前是否電子分音用的? CHING
打開之後我都俾佢嚇親
那二個膽座唔係 5V4G 亦唔係 6SN7 的.
頁:
[1]
2