damping factor 有冇條數計呢?
各位師兄, 請問damping factor 有冇條數可計出來呢? 因為個 spec 矛寫{:1_342:}Output power (both channel drive)
CD->SP OUT 80W+80W (8 ohms, 20Hz - 20kHz, THD 0.07%)
160W+160W (4 ohms, 1kHz, THD 0.7%)
THD 0.01% (Output-power-3dB o'clock, 1kHz, 8ohms)
Speaker output terminal Speaker AorB: 4ohms - 16ohms
Speaker A+B: 8ohm-16ohm
Bi-wiring load: 4ohms - 16ohms
<Preamplifier part>
Equalizer amplifier output Rec out:150mV
Input sensitivity/impedance Phono MM: 2.5mV/47kohm
Phono MC: 0.2mV/100 ohms
Line: 140mV/70kohm (Source-Direct-off)
140mV/30kohm (Source-Direct-on)
RIAA deflection Phono: 20Hz-20kHz±0.5dB
Pre-out output 1V (line system input [, such as CD, ] and 100mV of incoming signal o'clock)
<Synthesis>
Frequency response 5Hz-100kHz+0 -3 dB
Signal to noise ratio (A network)
Input terminal short circuit Phono MM: 91dB (at the time of a 5mV input)
Phono MC: 76dB (at the time of a 0.5mV input)
Line:110dB
Tone control Bass: ±8dB (100Hz)
Treble: ±8dB (10kHz)
Power receptacle switched: Two lines, the sum total capacity 120W
unswitched: One line, capacity 240W
Power supply voltage AC100V, 50Hz/60Hz
Power consumption 275W
Dimensions (a base, a knob, a terminal included ) Width 434x height 180x depth of 478mm
Weight 22.0kg
http://www.bcae1.com/dampfact.htm
謝謝師兄, 但是以下兩頂點先知呢？
Rated Damping Factor Into Above Load? =
Speaker Wire Gauge? = 本帖最後由 whitefang 於 2013-4-11 03:45 編輯
rated damping factor 要知道後級output z才計到
wire gauge就要自己查下條線 樓上答了{:8_402:} 謝謝兩位師兄{:1_330:}不過都係唔識找output z{:1_332:}
頁:
[1]